Page 1 of 1
How do I setup UT for Widescreen?
Posted: Wed Jul 14, 2010 1:26 pm
by Prozac
Ok....well my monitor died this morning,
so I went and got a new one. My old monitor was the square type of LCD. So now UT looks all out of wack on this new widescreen resolution.
Any tips on how to fix this? Thanks a million, Pro
Re: How do I setup UT for Widescreen?
Posted: Wed Jul 14, 2010 2:03 pm
by Porkinator
Go to <gameDir>\system. Open ut2004.ini. Find these lines:
FullscreenViewportX=xxxx
FullscreenViewportY=xxx
Change them to set your resolution.
Re: How do I setup UT for Widescreen?
Posted: Wed Jul 14, 2010 2:17 pm
by Prozac
Cool, thanks Porky!
Re: How do I setup UT for Widescreen?
Posted: Fri Jul 16, 2010 11:00 am
by law.of.averages
just cut 2" off the right side of your monitor... you'll be fine... no wait... better to cut 1" off each side so it's still balanced on the stand.
Re: How do I setup UT for Widescreen?
Posted: Fri Jul 16, 2010 11:30 am
by Porkinator
Don't tell him that.
He might try it.
Re: How do I setup UT for Widescreen?
Posted: Fri Jul 16, 2010 11:43 am
by Prozac
law.of.averages wrote:just cut 2" off the right side of your monitor... you'll be fine... no wait... better to cut 1" off each side so it's still balanced on the stand.
lol
Re: How do I setup UT for Widescreen?
Posted: Fri Jul 16, 2010 4:34 pm
by Duffy
Prozac wrote:law.of.averages wrote:just cut 2" off the right side of your monitor... you'll be fine... no wait... better to cut 1" off each side so it's still balanced on the stand.
lol
Holy S%#$%$ he tried it and now is trying to laugh it off
